1·The plume may extend into the cylinder bore a distance corresponding to the piston position.
羽流可延伸到汽缸膛中对应于活塞位置的一段距离。
2·Analyses the formation reasons, common characteristics and influence factors of diesel engine cylinder bore cavitation.
分析了柴油机缸套穴蚀形成原因、特征及其影响因素。
3·The split of the big end is sometimes at an angle, so that it is small enough to be withdrawn through the cylinder bore.
大头的裂口有时有一个角度，以便足够小通过气缸。
4·An integral contact model was established to analyze the cylinder bore deformation of model 493 automotive diesel engine.
建立了493车用柴油机缸孔变形的整体接触关系模型，提出了缸盖垫的非线性组合模型及缸套圆环模型。
5·Hot load and mechanical load coupling make piston to produce crackle, piston-ring glued and scuffing of cylinder bore and so on.
热负荷和机械负荷耦合将导致活塞产生裂纹、活塞环胶结以及拉缸等。
6·The process and economic benefit of laser heat treatment of cylinder bore for high speed diesel engine are described in this paper.
介绍了高速柴油机缸孔激光热处理工艺及其经济效益。
7·The honed cross hatch in cylinder bore of engine and the cylindricity of cylinder bore shall affect directly the operating mode and life of engine.
发动机缸孔平台网纹珩磨得是否合理和缸孔圆柱度的优劣直接影响到发动机的工况和寿命。
8·The experimental investigation on burning vaporised methanol in single cylinder testing engine with a cylinder bore of 130 mm through a vaporizer is presented in this paper.
本文介绍了在130单缸试验机上采用甲醇蒸发器掺烧甲醇的试验研究。
9·Reciprocating pumps convert rotary motion to linear motion. Pump speed in RPM determines the pumps output volume for any given combination of cylinder bore and piston stroke.
循环泵将曲轴旋转运动转化为柱塞的直线运动。泵速转每分钟决定了任何气缸和活塞组合的排泵量。
10·The parameter design of the plastic piston ring refers to designing the piston ring thickness, piston ring axial height and piston ring linear expansion in case that the cylinder bore is known.
塑料活塞环结构参量的设计是在缸径为已知量的前题下，分别对活塞环厚度、活塞环轴向高度、活塞环线胀量等进行设计。